CategoryFuel System

Posted October 12, 2021 Engine

Idle and Cold Start.

Now that the vacuum distribution block is fitted, I can work towards getting a solid idle. It wont be possible to get the idle perfect while the base map is … Continue Reading Idle and Cold Start.

Posted April 2, 2021 Chassis

Chassis Swap pt.2

Now that the engine is in the car I can work on getting it running. Fuel Tank The RA60 fuel tank won’t work with EFI so I put the 22RE … Continue Reading Chassis Swap pt.2

Posted January 18, 2021 Engine

First Engine Start

Before I could try to start the engine, I had to first check if the engine had oil pressure, and the ECU was recieving the required signals to start. I … Continue Reading First Engine Start

Posted March 7, 2020 Engine

Febuary 2020 Update

This month I have been tying off the loose ends as I am getting closer to starting the engine I had to make some changes to the engine harness for … Continue Reading Febuary 2020 Update

Posted September 29, 2019 Cooling

Installed the Haltech in the glove box. I ran the harness through the grommet that feeds into the wheel arch. The grommet can be accessed by first removing the dash … Continue Reading September Update

Posted June 23, 20194 Comments Cooling

Engine Installation

Now that the engine and transmission are bolted up to the correct position I can start put everything back into the engine bay. Apart from the nose being shorter, the … Continue Reading Engine Installation

Posted June 1, 20191 Comment Driveline

Fuel pump and sump modification

I received the parts needed to repair the fuel hanger from Aeroflow. The parts I used are below: AF413-06-05 – 90° Hose Barb 5/16″ to -6AN AF924-06 – Bulkhead Nut … Continue Reading Fuel pump and sump modification

Posted May 26, 2019 Fuel System

May 26 Update

I measured the location and dimensions of the ribbing on the bonnet as I need to check if there will be enough clearance to close the bonnet. It will be … Continue Reading May 26 Update

Posted March 8, 2019 Fuel System

4age 20v ITB’s

I had originally planned to use the beams intake, but decided that the benifits of changing to an ITB setup was worth the small cost increase These are the ITBs … Continue Reading 4age 20v ITB’s

Posted October 27, 2018 Fuel System

Fuel System

The original engine in the Celica was carburetted, so to run EFI the fuel system needs to be replaced. EFI Toyotas of this era typically had a return fuel system, … Continue Reading Fuel System